News

SMT Process Introduction

SMT process introduction

SMT refers to the surface mount technology, also known as surface assembly technology, is based on the printed circuit board PCB component SMT processing and welding, referred to as SMT. It is the most popular process for electronic products processing and welding. The basic process of SMT includes solder paste printing, electronic component mounting, reflow welding, AOI optical solder spot detection, X-ray perspective detection, maintenance, cleaning, etc. Nowadays, electronic products are increasingly seeking miniaturization, and the previous through-hole plug-in mode can not meet the current situation, so only surface mount technology CAN be used for SMT.

First of all, the basic process elements of SMT SMT processing are: solder paste printing (red glue printing), SPI, SMT, reflow welding, AOI detection, X-ray, repair, cleaning. Here's how each process works.
1. Printing solder paste: first, the printed circuit board is fixed on the printing positioning table, and then the solder paste or red glue is printed through the steel screen through the corresponding PCB pad by the scraper before and after the printing press, and the PCB with uniform printing is input to the next process through the transmission table. Solder paste and patch are thixodiants with viscosity. When the solder paste press moves forward at a certain speed and Angle, it produces a certain pressure on the solder paste, and pushes the solder paste to roll in front of the scraper, producing the pressure required to inject the solder paste into the mesh or leak hole. The adhesive friction force of solder paste produces shear at the junction between the scraper of solder paste printing machine and the net plate. The shear force reduces the viscosity of solder paste, which is conducive to the smooth injection of solder paste into the opening hole of the steel net.
2.SPI: SPI plays a significant role in the whole SMT SMT processing. It is fully automatic non-contact measurement, used after the tin printing press and before the SMT machine. 2D or 3D measurement (micron level accuracy) of solder after PCB printing is carried out by structural light measurement (mainstream) or laser measurement (non-mainstream) and other technical means. Principle of structured light measurement: a high-speed CCD camera is set in the direct direction of the object (PCB and tin), and a projector is used to irradiate periodic polarized light or images to the object from the oblique top. In the presence of a higher component on the PCB, an image is taken of the stripe shifting with respect to the base plane. Using triangulation principle, the offset value is converted to the balance value.

3. SMT: After SPI, the SMT machine is a device that accurately places surface mount components on the PCB pad by moving the mount head. It is used to achieve high speed, high accuracy of the device, is the SMT SMT processing and production of the most critical, the most complex equipment.
4. Reflow welding: Reflow welding is by remelting the solder paste pre-allocated to the PCB pad, to achieve mechanical and electrical connection between the solder end or pin of the surface assembly SMT processing element and the PCB pad. The reflow welding machine used in reflow welding is at the end of SMT line.
5.AOI: The scanning image is formed based on the reflection principle of light and the characteristics of different reflective ability of copper and substrate to light. The standard image is compared and analyzed with the actual plate layer image to judge whether the detected object is OK.
6.X-ray: The X-ray detection device penetrates the PCBA to be tested by X-ray, and then emits an X-ray image in the image detector. The image quality is mainly determined by resolution and contrast. This equipment is usually located in a separate room in the SMT workshop.
7. Repair: repair the PCB board with bad solder joints detected by AOI. Tools include soldering irons and heat guns. Repair positions are located anywhere on the production line.
8. Cleaning: cleaning is mainly to remove the solder slag on the PCBA board processed by the patch. The equipment used is a cleaning machine, which is fixed in the off-line back end or packaging area.

You Might Also Like

Send Inquiry